Sequence type encountered with 6 steps.
Would you like to cycle power for ALL active instruments? (y/n): [n]: y
Turning off power to all active instruments...
Waiting for 4 seconds for power supply bleed-down...
Turning on power supplies...
Skipping communication connect!
--Copying and transferring structure set...
--Post function loop...
[INFO | 07/28/14 15:28:13]:
== POWER CYCLE Command Status Summary ==
Instrument Location Active Status | Instrument Location Active Status |
--------------------------------------------------------------|--------------------------------------------------------------|
ctacf100 40E * (0) SUCCESS |
Executing 'final' function...
Waiting for 7 seconds for Cold Fire to boot back up...
Skipping communication connect!
--Copying and transferring structure set...
--Post function loop...
[INFO | 07/28/14 15:28:20]:
== RESET INSTRUMENT Command Status Summary ==
Instrument Location Active Status | Instrument Location Active Status |
--------------------------------------------------------------|--------------------------------------------------------------|
ctacf100 40E * (0) SUCCESS |
Waiting 22s for instruments to boot...
Pushing all cached timng and gain configuration values...
--Copying and transferring structure set...
--Post function loop...
OP TIMING.active_timing_setup = 5 [14ns_FIX_G]
[INFO | 07/28/14 15:28:42]:
== PUSH FULL CONFIG Command Status Summary ==
Instrument Location Active Status | Instrument Location Active Status |
--------------------------------------------------------------|--------------------------------------------------------------|
ctacf100 40E * (0) SUCCESS |
Setting gains
--Copying and transferring structure set...
--Initializing command...
--Executing command...
--Waiting for handshake completion...
<ctacf100> CMD_DONE (3)
--Post function loop...
gain setting = 5 (gain code = 272)
[INFO | 07/28/14 15:28:42]:
== SET GAINS Command Status Summary ==
Instrument Location Active Status | Instrument Location Active Status |
--------------------------------------------------------------|--------------------------------------------------------------|
ctacf100 40E * (0) SUCCESS |
Setting timing setup
--Copying and transferring structure set...
--Initializing command...
--Executing command...
--Waiting for handshake completion...
<ctacf100> CMD_DONE (3)
--Post function loop...
OP TIMING SETUP VALUE = 5 [14ns_FIX_G]
Block delays = 1039 857
<ctacf100> CMD_DONE (3)
gain setting = 0 (gain code = 0)
[INFO | 07/28/14 15:28:42]:
== SET TIMING SETUP Command Status Summary ==
Instrument Location Active Status | Instrument Location Active Status |
--------------------------------------------------------------|--------------------------------------------------------------|
ctacf100 40E * (0) SUCCESS |
Synchronizing all instrument turn counters... done.
[INFO | 07/28/14 15:28:43] Begin post-command status check/recovery: ...
--
MatthewStedinger - 28 Jul 2014